Hornady LNL Progressive Reloader with a TON of components

Hornady LNL AP with gobs of reloading supplies This is an older model but has an updated ejector, primer feeder, and has the case feeder base plate. It was bought new by my dad who passed away before he could use it. I have loaded less than 3000 rounds over the last 20 years, I’m just not using it anymore. I was never a competitor, just a plinker. It’s a great machine. I have had both Dillon and Hornady progressive presses and found them both to be high quality machines. The case feeder is a DIY project I built in my shop that works really well and has been used successfully with the 10mm auto but not tested with any other cartridge. No mods were done to the machine. It mounts to the press stand. It utilizes a low-tech Lee case hopper/ collator. And it also has a Mr. Bullet Feeder set up with Hornady 9mm and 10mm bullet feed dies which are new and unused. Includes the riser mount and ergonomic handle seen in the pics. Set of Large and Small Dillon Primer Pickup tubes. Dies: 9mm, .40/10mm, .45acp, .223 with LNL bushings and powder metering inserts for all 4 sets. 9mm, 10mm and .45 ACP dies also have carbide sizers and taper crimps. Shell plates: #1, #8, #10, #16 Lyman powder Scale Projectiles: over 1000 9mm 124 gr, copper washed. Over 2000 hard cast 10mm, 200gr (IIR) molly coated. Some .223 55gr. Brass: unknown quantities, but these are aprox 1 gallon jugs, see pics. 9mm lugar., 9mm mag, 10mm auto, 10mm mag, mix of .223/5.56, 7.63 x 39 Powder: kept in heat sealed plastic bags, unopened containers. 2lb Longshot, 1lb Accurate #9, 3lb Bullseye, 1lb reloader 15, 1lb Reloader 7, 1lb Accurate 2520, 1lb IMR4198. Primers: all kept heat sealed in plastic bags, mix of CCI, Federal, and Winchester. Large Pistol 3600, Small Rifle 3000, Small Pistol 2000. package deal. $1200 cash, Iwill consider trades. Located about 30 min from Taos, NM